Biamp 801I Manuel d'utilisateur télécharger pdf (Page 6)

Remote Control

Remote: The output level of an 801i mixer can be remotely controlled via an external potentiometer (5k~50k ohm linear taper) or ramp

control voltage (0~+10VDC). An RP-L1 remote control panel is available as an option (see diagram below). Potentiometers are wired high

(V), wiper (C), and low (

). Ramp voltage is wired positive (C) and ground(

). The Remote port of the 801i mixer must be enabled

before remote control of output level is possible (see Master DIP Switches on pg. 3). Remote control does not change physical settings on

the 801i mixer, it only attenuates from the maximum level settings established at the mixer.

green (to ' ')

red (to 'C')

white (to 'V')

low (ccw)

wiper

high (cw)

cwccw

REMOTE

RP-L1

25kΩ

linear

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Biamp 801I Manuel d'utilisateur Page 6